On Thu, May 16, 2019 at 6:56 AM Andre Przywara <[email protected]> wrote: > > Hi, > > this series enables USB support on the H6 boards. This is mostly just > adding some missing pieces here and there, the actual controller and PHY > are very similar to the previous ones, if not identical. > This is for the 2.0 ports only at the moment, USB 3.0 will be done > later (started porting Icenowy's Linux driver). > The Pine H64 shares a similar problem as the Pine64+ boards regarding > the upper USB port. To enable this port, we need the first patch > from the series [1] fixing this issue on the A64 boards. > > Patch 1 is a drive-by patch to bring SUNXI_GPIO to Kconfig, as this was > lingering in one of my branches for a while. > Patch 2 enables GPIO support for the H6, as this is needed for the Pine > H64 to enable the VBUS regulator. > Patch 3 adds the clock and reset gates mappings for the USB controller and > the PHY, the values are taken from the manual and verified against > Linux. > Patch 4 adds some code to the PHY driver to skip over not implemented > PHYs, as the H6 uses a PHY0/PHY3 combination in the DT. > Patch 5 then eventually enables USB in the existing defconfigs. > Patch 6 adds the .dts fixes required to get the upper USB port to work > on the Pine H64. > > Clément, can you please verify that this works for the Beelink box? > I guess the USB 2.0 port is probably the OTG one, so this setup would > look somewhat similar to the PineH64, which would allow you to copy > the USB DT nodes from there. > > Cheers, > Andre. > > [1] https://lists.denx.de/pipermail/u-boot/2019-May/369520.html > > Andre Przywara (6): > sunxi: move SUNXI_GPIO to Kconfig > sunxi: gpio: Enable support for H6 pin controller > sunxi: clocks: Add H6 USB clock gates and resets > sunxi: phy: Add USB PHY support for Allwinner H6 > sunxi: H6: Enable USB for existing boards > sunxi: Pine64: DTS: enable USB PHY 0 for HCI0
Except 6/6 (it can be part of DTS sync during MW) and rest Reviewed-by: Jagan Teki <[email protected]> -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/linux-sunxi/CAMty3ZAVU7_Oc_KHmJnPO-XCH22hKpWDrY%3Djpe3FOU356LezWA%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
