I have ftape compiled ( using unstable release from 9/11/99 )
have made the changes to the /etc/conf.modules file
but when i attempt to access the tape I get a message back that the
device is not configured.
I am sure that the dma and irq are probably wrong but i'm not sure how to
get the info. the
values used here were already entered when i went to edit the config.modules
file
here are messages from the logs
thanks for any help
--kamie
------
QIC-117 driver for QIC-40/80/3010/3020/Ditto 2GB/MAX floppy tape drives.
Compiled for Linux version 2.2.12
installing QIC-117 floppy tape hardware drive ...
ftape_init @ 0xc4823220.
zftape for ftape v4.03-pre-4 06/30/99
[000] zftape-init.c (zft_init) - zft_init @ 0xc4859a20.
[001] zftape-init.c (zft_init) - installing zftape VFS interface for ftape
driver ....
fdc-internal.c: fdc_internal_register @ 0xc48619b0.
[002] fdc-io.c (fdc_register_Rf0605625) - Probing for ftape-internal tape
drive slot 0.
[003] 0 fdc-internal.c (fdc_int_detect) - called with count 0.
[004] 0 fdc-internal.c (fdc_int_detect) - fdc[0] base: 0x0180, irq: 9,
dma: 3.
[010] 0 fdc-io.c (fdc_reset) - no drive polling interrupt!.
[011] 0 fdc-io.c (__fdc_command) - fdc not ready.
[012] 0 fdc-io.c (__fdc_issue_command) - __fdc_command(fdc, out_data,
out_count) failed: -16.
[013] 0 fdc-io.c (__fdc_command) - fdc not ready.
[014] 0 fdc-io.c (__fdc_issue_command) - __fdc_command(fdc, out_data,
out_count) failed: -16.
[015] 0 fdc-io.c (fdc_probe) - No FDC found.
[016] 0 fdc-io.c (fdc_reset) - no drive polling interrupt!.
___________________________________
lots more of the same going on...
