hi, i'm having troubles getting my usb controller going on
my acer travelmate 511t laptop (a member of the "travelmate
510" series).
i've tried all sorts of BIOS settings (although there
aren't many settings to change)
and i've tried different settings for 'pci' as suggested in
the dmesg: pci=biosirq,usepirqmask
but nothing seems to work. fyi, the laptop has a Ali m5237.
here's the relevant bits of my dmesg (appended below):
ohci_hcd: 2004 Feb 02 USB 1.1 'Open' Host Controller (OHCI)
Driver (PCI)
ohci_hcd: block sizes: ed 64 td 64
PCI: No IRQ known for interrupt pin A of device
0000:00:14.0.
ohci_hcd 0000:00:14.0: Found HC with no IRQ. Check
BIOS/PCI 0000:00:14.0 setup!
---- _I v o r y__K i t e____
jack andrews
university of mordialloc
vic australia [EMAIL PROTECTED]
Linux version 2.6.8-2-386
([EMAIL PROTECTED]) (gcc version 3.3.5
(Debian 1:3.3.5-12)) #1 Thu May 19 17:40:50 JST 2005
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000000bff0000 (usable)
BIOS-e820: 000000000bff0000 - 000000000bff8000 (ACPI data)
BIOS-e820: 000000000bff8000 - 000000000c000000 (ACPI NVS)
191MB LOWMEM available.
On node 0 totalpages: 49136
DMA zone: 4096 pages, LIFO batch:1
Normal zone: 45040 pages, LIFO batch:10
HighMem zone: 0 pages, LIFO batch:1
DMI 2.1 present.
ACPI disabled because your bios is from 2000 and too old
You can enable it with acpi=force
Built 1 zonelists
Kernel command line: root=/dev/hda1
pci=biosirq,usepirqmask ro
Local APIC disabled by BIOS -- reenabling.
Could not enable APIC!
Initializing CPU#0
PID hash table entries: 1024 (order 10: 8192 bytes)
Detected 332.965 MHz processor.
Using tsc for high-res timesource
Console: colour VGA+ 80x25
Dentry cache hash table entries: 32768 (order: 5, 131072
bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536
bytes)
Memory: 187420k/196544k available (1336k kernel code, 8472k
reserved, 732k data, 204k init, 0k highmem)
Checking if this processor honours the WP bit even in
supervisor mode... Ok.
Calibrating delay loop... 655.36 BogoMIPS
Security Scaffold v1.0.0 initialized
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
CPU: After generic identify, caps: 0183f9ff 00000000
00000000 00000000
CPU: After vendor identify, caps: 0183f9ff 00000000
00000000 00000000
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 128K
CPU: After all inits, caps: 0183f9ff 00000000
00000000 00000040
CPU: Intel Celeron (Mendocino) stepping 0a
Enabling fast FPU save and restore... done.
Checking 'hlt' instruction... OK.
Checking for popad bug... OK.
checking if image is initramfs...it isn't (ungzip failed);
looks like an initrd
Freeing initrd memory: 4216k freed
NET: Registered protocol family 16
EISA bus registered
PCI: PCI BIOS revision 2.10 entry at 0xf0200, last bus=1
PCI: Using configuration type 1
mtrr: v2.0 (20020519)
ACPI: Subsystem revision 20040326
ACPI: Interpreter disabled.
Linux Plug and Play Support v0.97 (c) Adam Belay
PnPBIOS: Scanning system for PnP BIOS support...
PnPBIOS: Found PnP BIOS installation structure at 0xc00f6490
PnPBIOS: PnP BIOS version 1.0, entry 0xfa000:0x0, dseg
0xf0000
pnp: 00:08: ioport range 0x1060-0x106f has been reserved
pnp: 00:08: ioport range 0xf100-0xf13f has been reserved
pnp: 00:08: ioport range 0xf140-0xf15f has been reserved
PnPBIOS: 15 nodes reported by PnP BIOS; 15 recorded by
driver
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
devfs: 2004-01-31 Richard Gooch ([EMAIL PROTECTED])
devfs: boot_options: 0x0
Initializing Cryptographic API
Activating ISA DMA hang workarounds.
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Serial: 8250/16550 driver $Revision: 1.90 $ 54 ports, IRQ
sharing enabled
ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024
blocksize
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
input: AT Translated Set 2 keyboard on isa0060/serio0
EISA: Probing bus 0 at eisa0
Cannot allocate resource for EISA slot 1
Cannot allocate resource for EISA slot 6
Cannot allocate resource for EISA slot 7
EISA: Detected 0 cards.
NET: Registered protocol family 2
IP: routing cache hash table of 1024 buckets, 8Kbytes
TCP: Hash tables configured (established 16384 bind 32768)
NET: Registered protocol family 8
NET: Registered protocol family 20
RAMDISK: cramfs filesystem found at block 0
RAMDISK: Loading 4216 blocks [1 disk] into ram disk... done.
VFS: Mounted root (cramfs filesystem) readonly.
Freeing unused kernel memory: 204k freed
vesafb: probe of vesafb0 failed with error -6
NET: Registered protocol family 1
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes;
override with idebus=xx
ALI15X3: IDE controller at PCI slot 0000:00:0f.0
ALI15X3: chipset revision 32
ALI15X3: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0x78c0-0x78c7, BIOS settings: hda:DMA,
hdb:pio
ide1: BM-DMA at 0x78c8-0x78cf, BIOS settings: hdc:DMA,
hdd:pio
hda: TOSHIBA MK3018GAS, ATA DISK drive
Using anticipatory io scheduler
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: max request size: 128KiB
hda: 58605120 sectors (30005 MB), CHS=58140/16/63, (U)DMA
/dev/ide/host0/bus0/target0/lun0: p1 p2 < p5 p6 p7 >
hdc: CD-224E, ATAPI CD/DVD-ROM drive
ide1 at 0x170-0x177,0x376 on irq 15
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Adding 562232k swap on /dev/hda5. Priority:-1 extents:1
EXT3 FS on hda1, internal journal
hdc: ATAPI 24X CD-ROM drive, 128kB Cache
Uniform CD-ROM driver Revision: 3.20
Synaptics Touchpad, model: 1
Firmware: 4.0
Sensor: 8
new absolute packet format
input: SynPS/2 Synaptics TouchPad on isa0060/serio1
Capability LSM initialized
mice: PS/2 mouse device common for all mice
ts: Compaq touchscreen protocol output
kjournald starting. Commit interval 5 seconds
EXT3 FS on hda6, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting. Commit interval 5 seconds
EXT3 FS on hda7, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
Linux Kernel Card Services
options: [pci] [cardbus] [pm]
PCI: Guessed IRQ 9 for device 0000:00:13.0
PCI: Sharing IRQ 9 with 0000:00:13.1
Yenta: CardBus bridge found at 0000:00:13.0 [1025:1002]
Yenta: ISA IRQ mask 0x0cb8, PCI irq 9
Socket status: 30000007
PCI: Guessed IRQ 9 for device 0000:00:13.1
PCI: Sharing IRQ 9 with 0000:00:13.0
Yenta: CardBus bridge found at 0000:00:13.1 [1025:1002]
Yenta: ISA IRQ mask 0x0cb8, PCI irq 9
Socket status: 30000411
usbcore: registered new driver usbfs
usbcore: registered new driver hub
ohci_hcd: 2004 Feb 02 USB 1.1 'Open' Host Controller (OHCI)
Driver (PCI)
ohci_hcd: block sizes: ed 64 td 64
PCI: No IRQ known for interrupt pin A of device
0000:00:14.0.
ohci_hcd 0000:00:14.0: Found HC with no IRQ. Check
BIOS/PCI 0000:00:14.0 setup!
Linux agpgart interface v0.100 (c) Dave Jones
agpgart: Detected ALi M???? chipset
agpgart: Maximum main memory to use for agp memory: 149M
agpgart: AGP aperture is 64M @ 0xe0000000
cpci_hotplug: CompactPCI Hot Plug Core version: 0.2
pci_hotplug: PCI Hot Plug PCI Core version: 0.5
pciehp: acpi_pciehprm:get_device PCI ROOT HID fail=0x1001
shpchp: acpi_shpchprm:get_device PCI ROOT HID fail=0x1001
PCI: Guessed IRQ 5 for device 0000:00:08.0
USB Universal Host Controller Interface driver v2.2
Real Time Clock Driver v1.12
input: PC Speaker
pnp: Device 00:0d activated.
parport: PnPBIOS parport detected.
parport0: PC-style at 0x3bc (0x7bc), irq 7, dma 1
[PCSPP,TRISTATE,COMPAT,ECP,DMA ]
irda_init()
NET: Registered protocol family 23
inserting floppy driver for 2.6.8-2-386
Floppy drive(s): fd0 is 1.44M
FDC 0 is a National Semiconductor PC87306
lp0: using parport0 (interrupt-driven).
NET: Registered protocol family 10
Disabled Privacy Extensions on device c02cc960(lo)
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 5
cs: IO port probe 0x0100-0x04ff: excluding 0x408-0x40f
0x480-0x48f 0x4d0-0x4d7
cs: IO port probe 0x0800-0x08ff: clean.
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0a00-0x0aff: clean.
cs: memory probe 0xa0000000-0xa0ffffff: clean.
eth0: Xircom: port 0x300, irq 3, hwaddr 00:10:A4:E5:4D:92
eth0: MII link partner: 45e1
eth0: MII selected
eth0: media 100BaseT, silicon revision 4
NET: Registered protocol family 17
eth0: no IPv6 routers present
-------------------------------------------------------
SF.Net email is Sponsored by the Better Software Conference & EXPO
September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices
Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA
Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf
_______________________________________________
Linux-usb-users@lists.sourceforge.net
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-users
