On Tue, 14 Dec 2004 11:03, you wrote: > Yes I know that there are different ways of doing it but I do not know > which is the best way. > > That is, before the gib board goes on I can change my methods.
Run trunking or conduit in the wall. Put a string into the trunking. Put a blanking plate over each end when the gib goes on. Later, when you've figured it out, remove the blanking plates, tie a wire (*and another string*) to the string you left in there and pull the wire through. The other string is for the next wire. Certainly you can't go wrong by just peppering the walls with RJ45 outlets (or blank plates with Cat 5e cable curled up behind). Label each end! Whatever you do- make detailed as-built drawings and photos of the interior of the walls (i.e. without gib) so at least you know where to punch holes in the future. Andy
