Must say Mike that i do not know the 'Puretek", is this a webcamera or a full digital
? Why did
you pick up on the OV511, any particular reason ?
I have a logitech webcam which is not supported by the latest kernels also my digitals
which
again are not. Have you tried gphoto ??
Mike Andrew wrote:
> I am trying to set up a small usb camera under Linux. A 'puretek PT-6007'
> (apparently)
>
> modprobe ov511 causes the following message stream in dmesg
>
> -----
> ov511.c: USB OV511 camera found
> ov511.c: camera: Puretek PT-6007
> usb-uhci.c: interrupt, status 3, frame# 1622
> ov511.c: reg read: error -84
> ov511.c: i2c write: error -84
> ov511.c: write regvals: error -84
> ov511.c: failed to configure OV76xx
> ov511.c: Failed to configure camera
> ov511.c: ov511 driver version 1.28 registered
> --------
>
> Note because of the last line, the module loads and modprobe is 'happy'
>
> Is this a camera problem or a beta usb problem? Are there some pointers you
> folks could give me, where to go next? I have looked at
> /usr/src/linux/Documentation/drivers/usb/ov511.txt, but don't want to delve
> too deeply into usb source code if possible.
>
> What 'applications' can I use to try this device out? Skippy?
>
> --
> http://linux.nf -- [EMAIL PROTECTED]
>
> _________________________________________________________
> Do You Yahoo!?
> Get your free @yahoo.com address at http://mail.yahoo.com
>
> _______________________________________________
> http://linux.nf -- [EMAIL PROTECTED]
> Archives, Subscribe, Unsubscribe, Digest, Etc
>->http://linux.nf/mailman/listinfo/linux-users
--
Keith Antoine aka "Skippy"
18 Arkana St, The Gap, Queensland, 4061, Australia PH: 61 7 33002161
Certified Professional Geriatric, Sometime Electronics Engineer, Knowall!!
Insensible phone computer assistance a speciality.
_______________________________________________
http://linux.nf -- [EMAIL PROTECTED]
Archives, Subscribe, Unsubscribe, Digest, Etc
->http://linux.nf/mailman/listinfo/linux-users
