Sorry you are wrong especially with USB. There is no way that aeither of my cameras
can get a
'dev' that corresponds. I have a real suspiscion that devfs would be able to see a
driver but
niot the setup as of now even with the latest jkernels. As you know I have been in
this for at
least 6 months now without success, thats why I had to reload M$
Jim Conner wrote:
> IIRC, you have to set it up similar to a usb hard drive/zip/ls120. This will
> give you the /dev/??? that corresponds to this device. You can then use some
> of the graphic/camera applications out there to use it. I haven't done this,
> but I'm just going on what I remember what I've read. If I'm wrong, please,
> somebody tell me.
>
> Jim
>
> On Saturday July 07, 2001 1:58 am, Mike Andrew wrote:
> > I am trying to set up a small usb camera under Linux. A 'puretek PT-6007'
> > (apparently)
> >
> > modprobe ov511 causes the following message stream in dmesg
> >
> > -----
> > ov511.c: USB OV511 camera found
> > ov511.c: camera: Puretek PT-6007
> > usb-uhci.c: interrupt, status 3, frame# 1622
> > ov511.c: reg read: error -84
> > ov511.c: i2c write: error -84
> > ov511.c: write regvals: error -84
> > ov511.c: failed to configure OV76xx
> > ov511.c: Failed to configure camera
> > ov511.c: ov511 driver version 1.28 registered
> > --------
> >
> > Note because of the last line, the module loads and modprobe is 'happy'
> >
> > Is this a camera problem or a beta usb problem? Are there some pointers you
> > folks could give me, where to go next? I have looked at
> > /usr/src/linux/Documentation/drivers/usb/ov511.txt, but don't want to delve
> > too deeply into usb source code if possible.
> >
> > What 'applications' can I use to try this device out? Skippy?
>
> --
>
> 1:42am up 14:46, 3 users, load average: 0.00, 0.06, 0.03
> ------------------------------------------------------------------------
> Running Caldera eD2.4 - Linux - because life is too short for reboots...
>
> _________________________________________________________
> Do You Yahoo!?
> Get your free @yahoo.com address at http://mail.yahoo.com
>
> _______________________________________________
> http://linux.nf -- [EMAIL PROTECTED]
> Archives, Subscribe, Unsubscribe, Digest, Etc
>->http://linux.nf/mailman/listinfo/linux-users
--
Keith Antoine aka "Skippy"
18 Arkana St, The Gap, Queensland, 4061, Australia PH: 61 7 33002161
Certified Professional Geriatric, Sometime Electronics Engineer, Knowall!!
Insensible phone computer assistance a speciality.
_______________________________________________
http://linux.nf -- [EMAIL PROTECTED]
Archives, Subscribe, Unsubscribe, Digest, Etc
->http://linux.nf/mailman/listinfo/linux-users
