Yes, I put. ./mkelfImage --kernel=/mnt/root/bzImage-17 --output=vmlinuz.vo --command-line="c onsole=/dev/ttyS0,115200n8 root=/dev/hda2"
----- Original Message ----- From: "Adam Agnew" <[EMAIL PROTECTED]> To: "rimy2000" <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Saturday, September 06, 2003 11:38 AM Subject: Re: about etherboot and mkelfImage > > Did you put this on your command like "console=ttyS0,115200" (change > 115200 for the baud you were using linuxbios at)? > > On Sat, 6 Sep 2003, rimy2000 wrote: > > > After I upgrade binutils to 2.14, mkelfImage 2.5 work find and the new output is > > > > Loading 172.27.4.23:vmlinuz.vo ...(ELF)... > > .......................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................done > > > > rhine disable > > > > Firmware type: LinuxBIOS > > > > but then I received nothing from serial. > > > > Any hint? > > > > Thanks!?> > > > _______________________________________________ > > Linuxbios mailing list > > [EMAIL PROTECTED] > > http://www.clustermatic.org/mailman/listinfo/linuxbios > > > > _______________________________________________ > Linuxbios mailing list > [EMAIL PROTECTED] > http://www.clustermatic.org/mailman/listinfo/linuxbios > _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios
