Thanks! I am so careless and after I changed console=/dev/ttyS0 to console=ttyS0 it works fine now.
----- Original Message ----- From: "Adam Agnew" <[EMAIL PROTECTED]> To: "rimy2000" <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Saturday, September 06, 2003 11:48 AM Subject: Re: about etherboot and mkelfImage > Nope, not "console=/dev/ttyS0,115200n8" you want "console=ttyS0,115200n8" > (or you can leave out the n8). Give that a shot. But first, as the last > mail said, test it under a normal bios (with the same command line!). > > > On Sat, 6 Sep 2003, rimy2000 wrote: > > > Yes, I put. > > > > ./mkelfImage --kernel=/mnt/root/bzImage-17 --output=vmlinuz.vo --command-line="c > > onsole=/dev/ttyS0,115200n8 root=/dev/hda2" > > > > > > ----- Original Message ----- > > From: "Adam Agnew" <[EMAIL PROTECTED]> > > To: "rimy2000" <[EMAIL PROTECTED]> > > Cc: <[EMAIL PROTECTED]> > > Sent: Saturday, September 06, 2003 11:38 AM > > Subject: Re: about etherboot and mkelfImage > > > > > > > > > > Did you put this on your command like "console=ttyS0,115200" (change > > > 115200 for the baud you were using linuxbios at)? > > > > > > On Sat, 6 Sep 2003, rimy2000 wrote: > > > > > > > After I upgrade binutils to 2.14, mkelfImage 2.5 work find and the new output > > > > is > > > > > > > > Loading 172.27.4.23:vmlinuz.vo ...(ELF)... > > > > .......................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................done > > > > > > > > rhine disable > > > > > > > > Firmware type: LinuxBIOS > > > > > > > > but then I received nothing from serial. > > > > > > > > Any hint? > > > > > > > > Thanks!?> > > > > > > > _______________________________________________ > > > > Linuxbios mailing list > > > > [EMAIL PROTECTED] > > > > http://www.clustermatic.org/mailman/listinfo/linuxbios > > > > > > > > > > _______________________________________________ > > > Linuxbios mailing list > > > [EMAIL PROTECTED] > > > http://www.clustermatic.org/mailman/listinfo/linuxbios > > > > > > > > > _______________________________________________ > Linuxbios mailing list > [EMAIL PROTECTED] > http://www.clustermatic.org/mailman/listinfo/linuxbios > _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios
