Thanks, but 1. My Kernel is workable under Normal BIOS, it is even workable under Linux BIOS without Etherboot. 2. Yes, I have added them:
./mkelfImage --kernel=/mnt/root/bzImage-17 --output=vmlinuz.vo --command-line="c onsole=/dev/ttyS0,115200n8 root=/dev/hda2" ----- Original Message ----- From: "YhLu" <[EMAIL PROTECTED]> To: "rimy2000" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]> Sent: Saturday, September 06, 2003 11:35 AM Subject: Re: about etherboot and mkelfImage 1. You need to verify your Kernel is workable under Normal BIOS. 2. when you using mkelfimage, you need add parameters for Console port and baud rate. YH. -----邮件原件----- 发件人: rimy2000 [mailto:[EMAIL PROTECTED] 发送时间: 2003年9月5日 20:24 收件人: [EMAIL PROTECTED] 主题: Re: about etherboot and mkelfImage After I upgrade binutils to 2.14, mkelfImage 2.5 work find and the new output is Loading 172.27.4.23:vmlinuz.vo ...(ELF)... ............................................................................ ............................................................................ ............................................................................ ............................................................................ ............................................................................ ............................................................................ ............................................................................ ............................................................................ .......................................................................done rhine disable Firmware type: LinuxBIOS but then I received nothing from serial. Any hint? Thanks! _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios
