On 9/13/06, Aleck Lin <[EMAIL PROTECTED]> wrote: > Hi, > > I'm able to boot Linux 2.6 on ML403 board (with a ramdisk file system). > > However, during the kernel booting, it complains that "No network devices > available," So I figured I probably didn't enable the ethernet driver in the > kernel. > > >From doing "make menuconfig", under "Device Drivers" --> "Network device > support" --> "Ethernet(10 or 100Mbit)", I checked the box of both "Ethernet > (10 or 100Mbit)" and "PowerPC 4xx on-chip Ethernet support." I then > save/exit the menuconfig to compile the kernel again. I've attached the > error output at the bottom.
The virtex eth device is not the same as 4xx on-chip Ethernet, so CONFIG_IBM_EMAC will not work. You need the xilinx_enet driver (which is not in mainline). It might be in MontaVista's 2.6 tree. I think people have posted patches for it to this list, so try searching the archives. (I don't have a link off the top of my head.) -- Grant Likely, B.Sc. P.Eng. Secret Lab Technologies Ltd. [EMAIL PROTECTED] (403) 399-0195 _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded
