Ordered the belt on Ebay based on the specs on the M100 FAQ. An 8.5" belt will require about an inch of stretch, but I suppose that is normal? I measured the belt path and came up with 9.5".
On Thu, Jul 23, 2015 at 9:38 AM, John R. Hogerhuis <[email protected]> wrote: > Club100 sells the replacement belts. Let me check the archives and see > if we have the specs so you can buy it directly if necessary. > > -- John. > > On Wed, Jul 22, 2015 at 1:50 PM, Barry Rands <[email protected]> wrote: > > Just opened up the drive and yes, the belt is in pieces. Do I need to > order > > from the club, or is this a stock part I can get from the local Radio > Shack > > or hardware store? > > > > On Wed, Jul 22, 2015 at 11:56 AM, Barry Rands <[email protected]> wrote: > >> > >> Bingo.... the TDD makes noise, so I thought the disk was turning... but > it > >> is not. Looks like I may need a new belt! Thanks! > >> > >> On Wed, Jul 22, 2015 at 9:23 AM, ultimate quantifier < > [email protected]> > >> wrote: > >>> > >>> floppy disks have a metal center ring with a notch. if you note the > >>> position of the notch and try to use it in the drive, then take it > out, the > >>> position of the notch should change indicating that the drive is > moving the > >>> disk at least. this may help you to figure out if the belt is suspect. > >>> > >>> > Date: Wed, 22 Jul 2015 09:09:58 -0700 > >>> > From: [email protected] > >>> > To: [email protected] > >>> > Subject: Re: [M100] TS-DOS "Not Found" > >>> > > >>> > > >>> > > >>> > Ken at club100 may be able to get one to you but I think he is a bit > >>> > busy with work right now. > >>> > Do you have a cassette cable? > >>> > I could save the dos100.co file as an mp3 file that you could use to > >>> > load ts-dos. Then you could format a new disk with it and save > dos100 to the > >>> > disk. A bit of a pain but it might get you up and running. > >>> > > >>> > Kurt > >>> > > >>> > > >>> > ------------------------------ > >>> > On Wed, Jul 22, 2015 7:49 AM PDT Barry Rands wrote: > >>> > > >>> > >No DIP switches on the TDD2. Drive is spinning, so diskette may be > >>> > > bad. Any > >>> > >way to get a new disk? > >>> > > > >>> > >On Wed, Jul 22, 2015 at 7:21 AM, Kurt McCullum < > [email protected]> > >>> > >wrote: > >>> > > > >>> > >> The disk could be bad or the drive itself might be bad. If the > drive > >>> > >> isn't spinning check the drive belt. It may be broken. Club100 > >>> > >> should have > >>> > >> spares. > >>> > >> > >>> > >> Kurt > >>> > >> > >>> > >> > >>> > >> On 7/22/2015 7:07 AM, Barry Rands wrote: > >>> > >> > >>> > >> Thanks for the response. I do have the original TS-DOS diskette in > >>> > >> the > >>> > >> drive. Could it be that the diskette is so old that the file has > >>> > >> become > >>> > >> corrupted with age? > >>> > >> > >>> > >> On Wed, Jul 22, 2015 at 6:29 AM, <[email protected]> wrote: > >>> > >> > >>> > >> TS-DOS is not built into the URII, only a loader program. TS-DOS > >>> > >> must > >>> > >> be on your TPD disk before it can be loaded. > >>> > >> > >>> > >> Sent by Outlook <http://taps.io/outlookmobile> for Android > >>> > >> > >>> > >> > >>> > >> > >>> > >> On Wed, Jul 22, 2015 at 6:21 AM -0700, "Barry Rands" > >>> > >> <[email protected]> > >>> > >>> > >> wrote: > >>> > >> > >>> > >> I just resurrected my Model 102 from storage and am trying to get > >>> > >> everything running. It has the UR-II ROM with TS-DOS built in, but > >>> > >> when I > >>> > >> connect the TDD2, all I get is "Not Found" when I enter the TS-DOS > >>> > >> program. > >>> > >> Any ideas of what might be wrong? > >>> > >> > >>> > >> -- > >>> > >> Barry Rands, PE, LEED AP > >>> > >> 81 Encanto Lane > >>> > >> San Luis Obispo, CA 93401 > >>> > >> 805-704-1549 (cell) > >>> > >> 805-783-2038 (home) > >>> > >> > >>> > >> > >>> > >> > >>> > >> > >>> > >> -- > >>> > >> Barry Rands, PE, LEED AP > >>> > >> 81 Encanto Lane > >>> > >> San Luis Obispo, CA 93401 > >>> > >> 805-704-1549 (cell) > >>> > >> 805-783-2038 (home) > >>> > >> > >>> > >> > >>> > >> > >>> > > > >>> > > > >>> > >-- > >>> > >Barry Rands, PE, LEED AP > >>> > >81 Encanto Lane > >>> > >San Luis Obispo, CA 93401 > >>> > >805-704-1549 (cell) > >>> > >805-783-2038 (home) > >>> > > >> > >> > >> > >> > >> -- > >> Barry Rands, PE, LEED AP > >> 81 Encanto Lane > >> San Luis Obispo, CA 93401 > >> 805-704-1549 (cell) > >> 805-783-2038 (home) > > > > > > > > > > -- > > Barry Rands, PE, LEED AP > > 81 Encanto Lane > > San Luis Obispo, CA 93401 > > 805-704-1549 (cell) > > 805-783-2038 (home) > -- Barry Rands, PE, LEED AP 81 Encanto Lane San Luis Obispo, CA 93401 805-704-1549 (cell) 805-783-2038 (home)
