Thanks Ken!
On Mon, Jun 4, 2018 at 9:44 PM, Ken Pettit <[email protected]> wrote: > Steve, > > There are two ways, depending on the version of firmware you have. > > 1. You can type "baud 76" (or "baud 76000" if you want) and hit enter. > It will switch immediately to the baud rate. The catch here is that > usually when you type commands at the ">" prompt, you expect feedback in > the form of characters echoed back to you. But when switching baud rates, > you kinda don't want to have to deal with bytes echoed back ... you are > about to change baud rates and have no control over the timing of the > switch. > > So NADSBox puts a guard time of a few hundred miliseconds around the 'b' > character when it is typed. The idea being if a human is typing it > interactively, then it will likely get echoed. But when sent from a > program, there would be little time between the 'b' and the 'a'. In this > mode, NADSBox will not echo the command. It will switch directly to 76000 > baud and expect the next character after the ENTER to be at 76000. > > Other baud rates supported by NADSBox: > > 9600 > 19200 > 38400 > 57600 > 76000 > 115200 > > You can optionally use just the first 2 numbers with the baud command. > > 2. I added a TPDD protocol extension for changing baud rates following > the standard "ZZ..." format. I don't recall the opcode number / format at > the moment. > > Ken > > > On 6/4/18 6:30 PM, Stephen Adolph wrote: > > I was just reading the manual.. didn't see a command for that though. if > you can pass along some info that would be great Ken-- > thx > Steve > > On Mon, Jun 4, 2018 at 9:22 PM, Ken Pettit <[email protected]> wrote: > >> NADSBox can support 76800. >> >> Ken >> >> >> On 6/4/18 6:22 PM, Stephen Adolph wrote: >> >> yah my pc cannot run at 76800 unfortunately. But.. what about NADSbox? >> >> On Mon, Jun 4, 2018 at 9:20 PM, John R. Hogerhuis <[email protected]> >> wrote: >> >>> >>> On Mon, Jun 4, 2018 at 6:13 PM Stephen Adolph <[email protected]> >>> wrote: >>> >>>> I intend to find out! for moving 1.6MB into the M100/T200, I think it >>>> should make a difference. >>>> >>>> My Rx loop reads a byte and places it directly in the target location. >>>> can't go much faster than that. >>>> >>>> >>> Cool! >>> >>> Just keep in mind that 76800bps is an odd rate. Some devices / drivers >>> support it and some don’t. Definitely worth the speed up for large files if >>> everything can’t handle it. >>> >>> Everything seems to support 38400. >>> >>> — John. >>> >>> >>> >> >> > >
