Thanks, Kurt. I have tried that but I keep getting REX 4.8 which I had
previously installed. Is there a different rex_flash.bin file for 4.9? If
so, where might it be obtained?
Bob
From: M100 [mailto:[email protected]] On Behalf Of Kurt McCullum
Sent: Thursday, July 26, 2018 5:47 PM
To: [email protected]
Subject: Re: [M100] VirtualT and REX 4.9
Bob,
I just did a setup of virtual-T with REX to see if I remembered the steps.
Here is how I did it.
1) Go to memory options
2) Select REX
3) Click the Create Default Flash button
4) Clock OK
5) Go to BASIC and type CALL 61167,2
That should start the virtual REX manager.
>From there you load BX images from wherever you have the virtual TPDD set to.
Hope that helps.
Kurt
On Thu, Jul 26, 2018, at 9:16 AM, Bob Pigford wrote:
Hello all. I have struggled to configure VT for REX 4.9. I understand REXMGR
and the OptROM.BX files, but I can’t seem to figure out which files to have and
in which folders they should reside for the REX 4.9 version (via REXMGR) to
appear. I would like to try again; I use the T200 emulation most of the time.
My searches for installation instructions have not been successful, but of
course, I am not the sharpest knife in the drawer.
Where might I find these instructions?
Thank you!
Bob
