Bob, Sorry for the late reply. Virtual-T installs 4.8. But if you download the 4.9 update from here: bitchin100.com/wiki/images/8/8f/R49_T200_236_rebuild.zip
You can upgrade it to 4.9. I took all three files and put them in my default TPDD folder. Then loaded rf249.co. From BASIC I cleared enough ram so than I could do a RUNM "RF249.CO" and then it upgraded Virtual-T to REX 4.9. That's the only way I know of to upgrade Virtual-T. I could send you the rex_flash.bin file from my machine if the upgrade doesn't work for you. Kurt On Sat, Jul 28, 2018, at 9:26 AM, Bob Pigford wrote: > Thanks, Kurt. I have tried that but I keep getting REX 4.8 which I > had previously installed. Is there a different rex_flash.bin file > for 4.9? If so, where might it be obtained?> Bob > > *From:* M100 [mailto:[email protected]] *On Behalf Of > *Kurt McCullum *Sent:* Thursday, July 26, 2018 5:47 PM *To:* > [email protected] *Subject:* Re: [M100] VirtualT and REX 4.9> > Bob, > > I just did a setup of virtual-T with REX to see if I remembered the > steps. Here is how I did it.> > 1) Go to memory options > 2) Select REX > 3) Click the Create Default Flash button > 4) Clock OK > 5) Go to BASIC and type CALL 61167,2 > > That should start the virtual REX manager. > > From there you load BX images from wherever you have the virtual > TPDD set to.> > Hope that helps. > > Kurt > > > On Thu, Jul 26, 2018, at 9:16 AM, Bob Pigford wrote: >> Hello all. I have struggled to configure VT for REX 4.9. I >> understand REXMGR and the OptROM.BX files, but I can’t seem to figure >> out which files to have and in which folders they should reside for >> the REX 4.9 version (via REXMGR) to appear. I would like to try >> again; I use the T200 emulation most of the time.>> >> My searches for installation instructions have not been successful, >> but of course, I am not the sharpest knife in the drawer.>> >> Where might I find these instructions? >> >> Thank you! >> >> Bob >> >
