>From Virtual-T go to Emulation -> Peripheral Setup. Select the radio button that says "Connect to simulated NADSBox".
Then click the 'Configure' button underneath that radio button. That will allow you to select the root directory. By default it is the same directory that Virtual-T is running in. That root directory is where you want to drop the three files. Hope that helps. Kurt On Sun, Jul 29, 2018, at 3:43 PM, Bob Pigford wrote: > Kurt, > I know this is a stupid question. Where is my “default TPDD folder” > under VT1_7? I do not see any folder named TPDD. When using the File > option “Load file from HD”, the directory that opens is in VT1_6 > showing my folders, but none indicating TPDD. Please be patient with > my ignorance here. I am struggling with this as the documentation for > guys like me is sparse.> Thank you, > Bob > > *From:* M100 [mailto:[email protected]] *On Behalf Of > *Kurt McCullum *Sent:* Sunday, July 29, 2018 6:00 PM *To:* > [email protected] *Subject:* Re: [M100] VirtualT and REX 4.9> > Bob, > > Sorry for the late reply. Virtual-T installs 4.8. But if you download > the 4.9 update from here:> > bitchin100.com/wiki/images/8/8f/R49_T200_236_rebuild.zip > > You can upgrade it to 4.9. > > I took all three files and put them in my default TPDD folder. Then > loaded rf249.co. From BASIC I cleared enough ram so than I could do a > RUNM "RF249.CO" and then it upgraded Virtual-T to REX 4.9. That's the > only way I know of to upgrade Virtual-T.> > I could send you the rex_flash.bin file from my machine if the upgrade > doesn't work for you.> > Kurt > > > On Sat, Jul 28, 2018, at 9:26 AM, Bob Pigford wrote: >> Thanks, Kurt. I have tried that but I keep getting REX 4.8 which I >> had previously installed. Is there a different rex_flash.bin file >> for 4.9? If so, where might it be obtained?>> Bob >> >> *From:* M100 [mailto:[email protected]] *On Behalf Of >> *Kurt McCullum *Sent:* Thursday, July 26, 2018 5:47 PM *To:* >> [email protected] *Subject:* Re: [M100] VirtualT and REX 4.9>> >> Bob, >> >> I just did a setup of virtual-T with REX to see if I remembered the >> steps. Here is how I did it.>> >> 1) Go to memory options >> 2) Select REX >> 3) Click the Create Default Flash button >> 4) Clock OK >> 5) Go to BASIC and type CALL 61167,2 >> >> That should start the virtual REX manager. >> >> From there you load BX images from wherever you have the virtual TPDD >> set to.>> >> Hope that helps. >> >> Kurt >> >> >> On Thu, Jul 26, 2018, at 9:16 AM, Bob Pigford wrote: >>> Hello all. I have struggled to configure VT for REX 4.9. I >>> understand REXMGR and the OptROM.BX files, but I can’t seem to >>> figure out which files to have and in which folders they should >>> reside for the REX 4.9 version (via REXMGR) to appear. I would >>> like to try again; I use the T200 emulation most of the time.>>> >>> My searches for installation instructions have not been successful, >>> but of course, I am not the sharpest knife in the drawer.>>> >>> Where might I find these instructions? >>> >>> Thank you! >>> >>> Bob >>> >> >
