Nice! I have been looking for one with the right angle plug.
On Tue, Dec 18, 2018, at 8:25 AM, Rick Shear wrote: > I use these... > https://www.ebay.com/itm/Panasonic-PQLV19-AC-DC-Power-Supply-Adapter-Charger-Output-6V-500mA/302298091261?hash=item46625ecefd:g:t1gAAOSwtGlZAnB1:rk:4:pf:0> > > The Panasonic PQLV19 works great, and no re-wiring required. > > On Tue, Dec 18, 2018 at 8:42 AM Jonathan Yuen > <[email protected]> wrote:>> Hello, >> >> I know it is the 'wrong' voltage but I've run my M100 on USB power >> supplies for charging phones and the like. Just needed to make the >> cable.>> >> Jonathan >> >> [email protected] >> ________________________________________ >> Från: M100 [[email protected]] för Peter Vollan >> [[email protected]]>> Skickat: den 18 december 2018 07:39 >> Till: [email protected] >> Ämne: Re: [M100] Model 100 power adapter >> >> The model 100 power suplly in center negative. >> Get a (approximately) 6 volt DC power supply. Then chop off the end>> and >> add the right connecor. ( and center negative.) >> >> On Mon, 17 Dec 2018 at 15:47, Kurt McCullum <[email protected]> >> wrote:>> > >> > I have had good luck using power supplies for TI calculators. They >> > seem to have the right plug and most are center positive.>> > >> > Kurt >> > >> > >> > On Mon, Dec 17, 2018, at 3:42 PM, gotoole wrote: >> > >> > Hi All >> > >> > I have 2 Power adapters for my model 100 both are now not working.>> > >> > Is their anything I can check to see why they are not working and >> > is it possible to get a replacement ?>> > >> > Regards >> > >> > Gordon >> > >> > >> > >> > Sent from my Samsung Galaxy smartphone. >> > >> > >> --- >> När du skickar e-post till SLU så innebär detta att SLU behandlar >> dina personuppgifter. För att läsa mer om hur detta går till, klicka >> här <https://www.slu.se/om-slu/kontakta-slu/personuppgifter/>>> E-mailing >> SLU will result in SLU processing your personal data. For >> more information on how this is done, click here >> <https://www.slu.se/en/about-slu/contact-slu/personal-data/>
