Yes, the M100/T102/200, TPDD 1 & 2, all the CRT-* CCR-* tape drives, all take the same 5.5x2.1mm size barrel connector, 6vdc, center negative. The only difference is some devices draw a few more milliamps than others, but none draws more than 400ma, so pretty much any adapter that outputs 500ma or more will work on everything related to an M100.
I personally like RadioShack 273-1763, wuth an "M" adaptaplug tip. The main part is tiny, the cord is thin, and the cord is just over 6ft long, and at 1800 ma it's never even coming close to burning out from the little 400ma load of any of these devices draw. But I don't think they make them new any more so you only get them from ebay. Only thing I don't like is where the thin cord meets the main part isn't protected from bending sharply, so if this was being used day to day with a portable device, being handled and flexed a lot, that cord would break right at the plug before too long. https://photos.app.goo.gl/12BZiCcXBBoNgqzU9 On Sat, Dec 29, 2018, 3:04 PM Ron Klein <r...@kdomain.org wrote: > Will this same power supply work with a TPDD unit, too? > > Thanks > > On Tue, Dec 18, 2018 at 10:27 AM Roger Mullins <km4...@gmail.com> wrote: > >> This one was recommended to me a while back and I picked it up for my >> M100. Works great! >> >> >> https://www.digikey.com/products/en/power-supplies-external-internal-off-board/ac-dc-desktop-wall-adapters/130?k=EPS060100&k=&pkeyword=EPS060100&pv52=6&mnonly=0&ColumnSort=0&page=1&quantity=0&ptm=0&fid=0&pageSize=25 >> >> -Roger >> >> >>> >>> > On Mon, Dec 17, 2018, at 3:42 PM, gotoole wrote: >>> > >>> > Hi All >>> > >>> > I have 2 Power adapters for my model 100 both are now not working. >>> > >>> > Is their anything I can check to see why they are not working and is >>> it possible to get a replacement ? >>> > >>> > Regards >>> > >>> > Gordon >>> >>>