If you're powering the device from the T200 itself, perhaps it's not getting enough power?
On Fri, Oct 4, 2019 at 4:36 PM Stephen Adolph <[email protected]> wrote: > does your T200 work with just normal serial cable to a PC? > My M100 was acting like this and it had a dead UART chip. > I don't think REX is the cause but you can always pull it and see if it > makes a difference? > steve > > On Fri, Oct 4, 2019 at 4:12 PM Russell Davis <[email protected]> > wrote: > >> Going slowly potty. I have a WiFI32 which is a wifi "modem" (esp8266 and >> some serial glue) and it works perfectly on the M102 with or without >> flow control set in stat (58N1D and 58N1E) but I can't get it to work to >> work on the T200. set STAT to 58N1ENN, 58N1DNN, 58N1DNI,... and in TERM >> if I type a character it freezes hard. only thing that works is to power >> cycle. if i'm in bank 2 it seems to return to the telcom program and >> next character appears but typing another character freezes the T200 >> again. I suspect it's something to do with flow control but completely >> flummuxed. >> >> Are there major differences between the M100/102's rs232 and the T200's? >> or could the REX that is in the T200 be causing problems? I can't see >> how it could be but i'm grasping at any straws that could be around. >> >> >> bst rgrds >> >> Russell >> >> -- Scott Lawrence [email protected]
