powering from USB on both m102 and t200.
-Russell
On 10/4/2019 4:45 PM, Scott Lawrence wrote:
If you're powering the device from the T200 itself, perhaps it's not
getting enough power?
On Fri, Oct 4, 2019 at 4:36 PM Stephen Adolph <[email protected]
<mailto:[email protected]>> wrote:
does your T200 work with just normal serial cable to a PC?
My M100 was acting like this and it had a dead UART chip.
I don't think REX is the cause but you can always pull it and see
if it makes a difference?
steve
On Fri, Oct 4, 2019 at 4:12 PM Russell Davis
<[email protected] <mailto:[email protected]>> wrote:
Going slowly potty. I have a WiFI32 which is a wifi "modem"
(esp8266 and
some serial glue) and it works perfectly on the M102 with or
without
flow control set in stat (58N1D and 58N1E) but I can't get it
to work to
work on the T200. set STAT to 58N1ENN, 58N1DNN, 58N1DNI,...
and in TERM
if I type a character it freezes hard. only thing that works
is to power
cycle. if i'm in bank 2 it seems to return to the telcom
program and
next character appears but typing another character freezes
the T200
again. I suspect it's something to do with flow control but
completely
flummuxed.
Are there major differences between the M100/102's rs232 and
the T200's?
or could the REX that is in the T200 be causing problems? I
can't see
how it could be but i'm grasping at any straws that could be
around.
bst rgrds
Russell
--
Scott Lawrence
[email protected] <mailto:[email protected]>
