Hi Tim, FYI, the Stretch + Axis + MK memory leak is about 1MByte per min.
Not sure what the differents for Axis under LinuxCNC and MachineKit. Regards, KL Chin On Tuesday, 14 August 2018 10:02:24 UTC+8, KL Chin wrote: > > Hi Tim, > > I did quick test Stretch + Axis, just turn on without run the milling with > default gcode. > > a) MachineKit - memory leakage > b) LinuxCNC - no leakage > > Regards, > KL Chin > > > > On Tuesday, 14 August 2018 00:09:23 UTC+8, KL Chin wrote: >> >> Hi Tim, >> >> I tested 2 version. >> >> a) RealtimePi + MachineKit (ver 0.1) >> b) RPi Stretch + LinuxCNC (2.8.1-Pre) >> >> So far, both no memory leakage. >> >> Maybe I will try without running the code. >> >> Regards, >> KL chin >> >> >> On Monday, 13 August 2018 21:04:10 UTC+8, Timothy March wrote: >>> >>> To KL Chin >>> I just setup Stretch SDcard again last night and tried it briefly before >>> I left for work today. Gcode I am using is Machinekit Splash Goode. I just >>> start Axis and open Htop I do not have to run code screen just displaying >>> Axis memory usage climbs very slowly. When I found this a wile back it to >>> over 36 hours to eat up all available memory. If you shut down Axis memory >>> returns to normal >>> >>> Tim >>> >> -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
