Hi Tim, I still testing both.
1) LinuxCNC had already 2.8 but MachineKit still based on 2.6. 2) The StepConf was so slow with MachineKit. 3) The Gui sample works on LinuxCNC BTW. I had attached the hal_gpio.so for LinuxCNC, may be you can try it. Just copy to LinuxCNC rtlib folder. I just change few lines of the hal_gpio.c. Regards, KL Chin On Tuesday, 28 August 2018 03:42:31 UTC+8, Timothy March wrote: > > KL Chin why are you using LinuxCnc instead of Machinekit? The hal_gipo > only works with Machinekit there is no gipo driver for LinuxCnc. > > Tim > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
hal_gpio.so
Description: Binary data
