Have you registred the map in a coordinat system and have it as a raster layer
in your map window? If so you just creates a new table/layer and add to that
map window and make sure taht the layer is editable and use the digitizing
tools (which are dimmed down if ther is no editable table). I have never worked
in MI 3, but I hope thats how it works in that release also.
//Hälsningar / Regards
Gustaf Svedjemo
~~~~~~~~~~~~~~~~~~~~~
Högskolan på Gotland / Gotland University College
Cramérgatan 3
S-621 57 Visby
Sweden
E-post / Email: [EMAIL PROTECTED]
Tel / Phone: +46 (0)498 29 98 86
Fax: +46 (0)498 29 98 32
Mobil / Cell: +46 (0)708 858 126
WWW: http://www.hgo.se
~~~~~~~~~~~~~~~~~~~~
> -----Ursprungligt meddelande-----
> Från: Martin Bolte [SMTP:[EMAIL PROTECTED]]
> Skickat: den 24 januari 2001 18:48
> Till: [EMAIL PROTECTED]
> Ämne: MI-L Digitizer Setup
>
> Hi Folks,
> I am currently working with quite an old version of Mapinfo (3.0.5) and
> I#m quite a Newbie with Mapinfo. My Problem is to get into the Digitizer
> Setup. I'm working with a scanned in Map ( as a gif file) and with data
> I've taken with GPS an my site. Can anybody tell me where and how I can
> activate this Digitizer Setup (without having a digitizing board)??? Must
> be possble.
> Thanks
> Martin
>
>
> _______________________________________________________________________
> List hosting provided by Directions Magazine | www.directionsmag.com |
> To unsubscribe, send e-mail to [EMAIL PROTECTED] and
> put "unsubscribe MapInfo-L" in the message body.
_______________________________________________________________________
List hosting provided by Directions Magazine | www.directionsmag.com |
To unsubscribe, send e-mail to [EMAIL PROTECTED] and
put "unsubscribe MapInfo-L" in the message body.
