Dear Gorazd, I am looking at power injection models of TCSC, SSSC and UPFC in MATPOWER, these however has to do with my work. I will appreciate your view on the following questions. 1) Run CPF with FACTS, is this visible for load ability increment? 2) May I request that I reach out to you for clarifications as the need arises
In anticipation of your response. Regards Ahmad On Sep 28, 2017 8:27 AM, "Bone, Gorazd" <[email protected]> wrote: > Hi, I missed this discussion somehow. I model FACTS devices using MatPower > too and will gladly upload it when the thing is finished. The method is > very similar to the taps and phase analysis that I githubbed earlier. > > Please give a heads up which way your intended FACTS modelling is headed. I > would have to see which way MatPower's FACTS modelling will go, because I > don't think it's good to mix very differrent types of methods since > convergence characteristics will usually tend to get muddy. > > Regards, Gorazd > > > ------------------------------ > *Od:* [email protected] [ > [email protected]] v imenu Ray Zimmerman [ > [email protected]] > *Poslano:* 27. september 2017 21:06 > *Za:* MATPOWER discussion forum > *Zadeva:* Re: FACTS INCLUSION > > Let’s coordinate off-line initially, and then, on MATPOWER-DEV-L when it > makes sense. > > Ray > > On Sep 27, 2017, at 2:38 PM, Ahmad Sadiq Abubakar < > [email protected]> wrote: > > Thank you Ray for the reply, > I wish to coordinate with you on this front. > How to I get involved and when likely are we going to start. > > I was the one who contributed the voltage and branch limits enforcement in > CPF termination. > > Regards. > Ahmad. > > On Sep 27, 2017 7:33 PM, "Ray Zimmerman" <[email protected]> wrote: > > I am not aware of anything specific being worked on at the moment related > to FACTS devices. However, over the next year, I plan to do some > refactoring of some of the core of MATPOWER to generalize things in a way > that should make modeling FACTS devices much easier. So, anyone seriously > planning to work on this area may want to coordinate with me. > > Ray > > > > On Sep 27, 2017, at 2:14 PM, Ahmad Sadiq Abubakar < > [email protected]> wrote: > > > > Hi all, > > Is there any development or progress on FACTS models inclusion in > MATPOWER? > > > > Or rather what is the progress so far? Can I be involved in it? > > > > In anticipation of your responses. > > > > > >
