Let's see... How did you install the capture agent? Did you use the official scripts?
If you didn't, did you modify the "Makefile"? If you didn't, you need to look for the section "load" and modify the line starting by "insmod", adding the following "v4l_num_buffers=2". If this does not work, I must confess I don't know what else it can be... Good luck 2012/2/22 Frank Van Damme <[email protected]> > 2012/2/22 Rubén Pérez <[email protected]>: > > OK, then. Is there any video feed attached to the card? Please note that > the > > pipeline (and most calls to the device whatsoever) will fail if no > signal is > > received. > > There is, I test with my laptop as well as with the capture agent > itself (on which I installed X11). As you may be able to tell from the > mencoder test, the output resolution is detetced: see the line > > Supported sizes: 1280x1024 => 1280x1024 > > This changes if I set my output resolution to eg. 1024x768. > > -- > Frank Van Damme > No part of this copyright message may be reproduced, read or seen, > dead or alive or by any means, including but not limited to telepathy > without the benevolence of the author. > _______________________________________________ > Matterhorn-users mailing list > [email protected] > http://lists.opencastproject.org/mailman/listinfo/matterhorn-users >
_______________________________________________ Matterhorn-users mailing list [email protected] http://lists.opencastproject.org/mailman/listinfo/matterhorn-users
