Nah, my 1200 hasnt had electronic ignition before but sounds like an easy
wire up. Cheers again.

Scott

-----Original Message-----
From: andrew smith <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED] <[EMAIL PROTECTED]>
Date: Sunday, 22 October, 2000 22:35
Subject: Re: coils for A14


>Scott,
>It depends, if you already have the electronic dizzy fitted then you
probably
>already have a 12 volt coil with no resistor so it should wire straight up
if
>not just bypass the resistor.
>Andrew Smith
>Davidson wrote:
>
>> Cheers Andrew.  Everyone i have spoken to has said the same thing.  The
>> bosch units will be able to perform just as well.  Is there any re-wiring
>> needed to fit these into a 1200 loom or is just a bolt on connect up
job??
>>
>> Scott
>>
>> -----Original Message-----
>> From: andrew smith <[EMAIL PROTECTED]>
>> To: [EMAIL PROTECTED] <[EMAIL PROTECTED]>
>> Date: Friday, 20 October, 2000 22:08
>> Subject: Re: coils for A14
>>
>> >Check with bosch as they have T-coils to suit most electronic ignition
and
>> >there pretty cheap( under $50 ). They usually out perform most
aftermarket
>> type
>> >coils in tests. I've used them for years without any problems.I know a
guy
>> who
>> >uses one on a FJ20 that puts out 344 HP at the back wheels and revs to
9000
>> >rpm.
>> >Andrew Smith
>> >
>> >Davidson wrote:
>> >
>> >> OK....time to buy a coil for the A14 race engine - electronic
ignition.
>> >>
>> >> Whats peoples thoughts on Arlec supercoils???  Are they up to the job?
>> Any
>> >> other coils that people have used and recomend?? Bosch have anything
to
>> >> suit??
>> >>
>> >> Cheers
>> >>
>> >> Scott
>> >> Davo
>> >>
>> >
>> >
>>
>
>

--membersozdat-------------------------------------------------------
OZDAT Mailing List   Please Note:-
Send (un)subscribe requests to  [EMAIL PROTECTED]
Send  submissions to  [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------

Reply via email to