Terry,
Thanks for your reply. The auto trans is off, but the torque
converter is still on the flywheel. I want to put a manual flywheel on it
but I cant see any bolts to undo, apart from a cylinder with flats on it in
the middle of the torque convertor. Is this what takes the conterter off?
When I tried to turn it but the crank moves. I got a mate to get a spanner
on the other side of the crank while I turned the flats on the centre of the
torque converter but it would not budge. Should I try harder? or is this the
wrong method. I cant see any way else.
Thanks.
Justin
> Justin,
>
> The procedure to remove an auto trans is much the same as a shifter until
> you get to the converter. It just unbolts from the drive plate. If you
> need
> the full version of how to take an auto out just ask.
>
> regards
> Terry
>
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Justin
> Friedrichs
> Sent: Monday, 5 March 2001 1:44
> To: '[EMAIL PROTECTED]'
> Subject: RE: setting up an L18
>
>
>
>
> List
>
> > Does, anyone know how to remove a torque convertor from a L18. The only
> > way I can see to do it is to remove the large centre round piece with
> > flats by using a shifter and a socket holding the nut on the other side
> of
> > the crank. Can any one help?
> > Justin.
> >
> >
> >
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
