RE: Z series stuff again

[Richardson, Thomas Morgwn - RICTM002]

20mm greater block height, you will probably find that the bonnet wouldn't close very well if you used reversed L series mounts, as my Z20 only barely clears the plenum.  Fixing this will require custom or slotted engine mounts.   Z24 blocks are supposedly weak though -----Original Message----- From: David Costello [mailto:[EMAIL PROTECTED]] Sent: Sunday, 2 December 2001 11:20 PM To: [EMAIL PROTECTED] Subject: Z series stuff again is there any physical size difference in the Z20 and Z24 blocks?   will the Z24 block bolt onto the same mounts as a Z18?   I was just considering just using a whole Z24 bottom end instead of going to all the trouble of putting the Z24 crank in the Z20 block, trying to weigh up pro's and cons   Dave --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------