hi, i bought that sellys all clear when it first came out....i never bought
it again cause it didnt set  as  firm as silicon , even though it did set to
a certain point.
i still use the paper gasket and gasket sealant.

mark k
----- Original Message -----
From: "Daniel Kroehn" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, December 11, 2001 11:27 PM
Subject: Re: Seals and gasket goo


> I know this will sound really dodgy, but when I fixed by diff breather, I
> used selly's All-Clear silicon on the rear case and the diff
> housing...............Not a leak yet!
> But I will look into using the hylomer stuff you recommended when I put
the
> engine back together at the end of the week.  Do you still use the paper
> gaskets as well as the gasket sealant?
>
> Cheers
>
> Daniel (very tired) Kroehn
>
> ----- Original Message -----
> From: "mark krawczuk" <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Tuesday, December 11, 2001 10:15 PM
> Subject: Re: Seals and gasket goo
>
>
> > hi,      as  far as i know , that some late model  cars use  rubber
> sealing
> > compuund on the engines from the factory.
> >
> >  by the way grease aint gonna seal up any thing on a  irregular surface,
> > whereas silicon will, thermostat housings, timing covers.
> > etc.............
> >
> >  mark k
> > ----- Original Message -----
> > From: "Fergy" <[EMAIL PROTECTED]>
> > To: <[EMAIL PROTECTED]>
> > Sent: Tuesday, December 11, 2001 9:49 AM
> > Subject: Re: Seals and gasket goo
> >
> >
> > > Daniel,
> > >
> > > I am not sure about the seals, never heard of that
> > > problem before.
> > >
> > > As far as Goo goes, why use any ?? I hate the stuff
> > > personally. If both mating surfaces are FLAT and CLEAN
> > > a gasket that has a very light film of grease on both
> > > sides will do the job.
> > >
> > > Why grease ?? Makes it easy should you ever have to
> > > pull the engine down again later. I have built a
> > > number of Engines, always used this procedure and
> > > NEVER had a leak. Obviously I don't use grease on the
> > > Head or Inlet mani gaskets.
> > >
> > > Regards
> > >
> > > Bruce
> > >
> > > __________________________________________________
> > > Do You Yahoo!?
> > > Send your FREE holiday greetings online!
> > > http://greetings.yahoo.com
> > >
> > >
> > >
> >
> >
>
>


--membersozdat-------------------------------------------------------
OZDAT Mailing List   Please Note:-
Send (un)subscribe requests to  [EMAIL PROTECTED]
Send  submissions to  [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------

Reply via email to