Re: Rear crossmember hole for 3 inch exhaust

[mark krawczuk]

hi,  on my rear cross member i  didnt , and  u dont have to cut out a round hole. i cut  mine sorta  rectangular  shape, plated above , below and inside with about 3mm plate  steel, that way u have a bigger hole,  can weld the plate so that its flush.        mark k ----- Original Message ----- From: Daniel Kroehn To: [EMAIL PROTECTED] Sent: Friday, January 04, 2002 7:26 PM Subject: Rear crossmember hole for 3 inch exhaust Hey guys and gals,   just wondering what  size pipe to use when I cut the old exhaust hole out of my rear crossmember to fit my 3 inch exhaust system.  I have a piece of four inch pipe but it is 8mm thick!!!!!!!!!!!!  I would have to cut the entire guts out of the crossmember to make it fit, i.e from top to bottom. Thanks   Daniel Kroehn Z18et only a few weeks away.................................. --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------