RE: retractable belts in 1600

[Terry Rudd]

The Oz models do actually have a hole (no thread) in the B pillar but not used as it didn't pass safety regs here, and if you've ever seen a 1600 involved in a minor shunt in the B pillar area you'd understand why it's not good for your health to use that mounting point. The top throat cutter mount is only marginally better which is why we use the hangers designed for coupes as replacements.   regards Terry -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of maldat Sent: Saturday, 16 February 2002 8:01 AM To: [EMAIL PROTECTED] Subject: Re: retractable belts in 1600 Some seat belt bolt on to the 5/8 mark up the B piller(comen) Now the one at the bottom of the B piller also has one about 4" back from that one. Their is also a top one under the roof linning about where the rear hand grabs are. Every NZ made 510 has the two sets of holes just like the Japanese ones,So I just thought they all did. NOTE"+ some are welded up factory but you can see where to drill. Malcolm Terry Rudd wrote:  Malcolm/Zac,Before you two come to blows the Oz 1600 4 door only has one set of seatbelt mounting holes - it's only the Japanese models including the wagon that has additional blanked off holes in the floor and if I'm not mistaken these are only for the adjusting belts (either side of the tunnel) I'm not sure what they're even for, may be some different width seats used in the Japanese models?regardsTerry -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of maldat Sent: Friday, 15 February 2002 5:24 PM To: [EMAIL PROTECTED] Subject: Re: retractable belts in 1600   I did read your post,and I worked that out all by my self.Thanks any way. If you had read my last post you would be better off as it answers your questions Malcolm (the holes in the floor to move your seats over are allready under your carpet) Zac Campbell wrote:  Read my original post - I have non-factory seats. zac   --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------