|
yep, i numbered them, then found out the 2nd,3rd,
and 4th are cast numbered 11, 12, and 13, and the 1st one has the bolt holes for
the plate that keeps the cam in
----- Original Message -----
Sent: Tuesday, February 19, 2002 10:00
PM
Subject: Re: cam towers
They only bolt on in one place,just keep them 1,2,3,4.And know
which one is number 1.
I have swaped over cams,heads,rockers,and never had
a problem.
NOTE.just watch out for the little dowels,underneath the
towers,I have broken one cam cos I didn't look at what I was doing.
Malcolm
Ben wrote:
if i take the cam towers off, will a head
machining shop be able to re-align when i get it planed etc??
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
--------------------------------------------------------------------- |
