Andrew, When you're looking at easy replacement seats for a 1600 the runners from the donor car aren't all that important as you never (rarely anyway) use them. What you're looking for is a flat underside so the original 1600 runners can easily be re-attached to you donor seats. Stanza, U13 and Pulsar and I think even R32 seats all fall into this category. I made an assumption that this is what you were after, I could be wide of the mark though (known to happen (-: )
regards Terry -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Andrew Greenbury Sent: Friday, 22 February 2002 11:46 AM To: [EMAIL PROTECTED] Subject: RE: Seat supports... Terry, Hmm I might have to check out the stanza again, but the ones I saw yesterday appeared to use the separate mounts front and rear to the seat rails, not the single frame per side like the 1600. I will also try to locate a U13 too thanks... The reason I am trying to locate these taller supports is to be able to tilt the seat forward a little for a better position, but without making seat frame support modifications. Thanks Andrew > Andrew, > > U13 is the only one I can think of that comes close to your description but > I'm not sure that the distance between the bolts are exactly the same as a > 1600. Stanza also uses much the same idea as the 1600, the rails are the > same height and the rear bolt holes are the same distance apart but the > front mounts are different to the 1600. > > regards > Terry > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]On Behalf Of GREENBURY, > Andrew Robert > Sent: Thursday, 21 February 2002 7:19 PM > To: [EMAIL PROTECTED] > Subject: Seat supports... > > > Hi Everyone, > > You know the seat support frames that bolt into the floorpan, that the > seat rails then bolt on to?? Does anybody know of another car that uses > the same setup as the 1600? > > I had a look at every datsun/nissan at the local wreckers, and it appears > none of them use a frame for each side like the 1600, but instead a > separate mount at each end of each seat rail... > > The thing is, I have a pair of support frames that are exactly the same > dimensions as the 1600 ones, except about 20mm higher. But I can not find > out what they are from?! > > Thanks for any light anyone can shed, > > Andrew > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
