Terry, yeah I am after the triangular supports that bolt to the floorpan, that the seat runners/rails and seat then bolt to. It is a bit tricky to describe as there is no universal "seat terminology" :) I know there is a car out there that has the same form as the 1600s but 20mm higher because I have a pair, but dont know where they came from in order to get the other side :)
Know what I mean?! thanks Andrew > Andrew, > > When you're looking at easy replacement seats for a 1600 the runners from > the donor car aren't all that important as you never (rarely anyway) use > them. What you're looking for is a flat underside so the original 1600 > runners can easily be re-attached to you donor seats. Stanza, U13 and Pulsar > and I think even R32 seats all fall into this category. I made an assumption > that this is what you were after, I could be wide of the mark though (known > to happen (-: ) > > regards > Terry > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]On Behalf Of Andrew > Greenbury > Sent: Friday, 22 February 2002 11:46 AM > To: [EMAIL PROTECTED] > Subject: RE: Seat supports... > > > Terry, > > Hmm I might have to check out the stanza again, but the ones I > saw yesterday appeared to use the separate mounts front and rear > to the seat rails, not the single frame per side like the 1600. I will > also try to locate a U13 too thanks... > > The reason I am trying to locate these taller supports is to be able > to tilt the seat forward a little for a better position, but without > making seat frame support modifications. > > Thanks > Andrew > > > Andrew, > > > > U13 is the only one I can think of that comes close to your description > but > > I'm not sure that the distance between the bolts are exactly the same as a > > 1600. Stanza also uses much the same idea as the 1600, the rails are the > > same height and the rear bolt holes are the same distance apart but the > > front mounts are different to the 1600. > > > > regards > > Terry > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED]]On Behalf Of GREENBURY, > > Andrew Robert > > Sent: Thursday, 21 February 2002 7:19 PM > > To: [EMAIL PROTECTED] > > Subject: Seat supports... > > > > > > Hi Everyone, > > > > You know the seat support frames that bolt into the floorpan, that the > > seat rails then bolt on to?? Does anybody know of another car that uses > > the same setup as the 1600? > > > > I had a look at every datsun/nissan at the local wreckers, and it appears > > none of them use a frame for each side like the 1600, but instead a > > separate mount at each end of each seat rail... > > > > The thing is, I have a pair of support frames that are exactly the same > > dimensions as the 1600 ones, except about 20mm higher. But I can not find > > out what they are from?! > > > > Thanks for any light anyone can shed, > > > > Andrew > > > > > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
