cause i got some new vt calipers with pads dirt,dirt cheap, cheaper than what i could get vl calipers/. plus vl calipers crap me off...:-o
mark k ----- Original Message ----- From: "Kristian Walsham" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Friday, March 14, 2003 12:38 PM Subject: Re: brake conversion. > Why not just use VL calipers? > > > Kris. > ----- Original Message ----- > From: "mark krawczuk" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Friday, March 14, 2003 12:55 PM > Subject: brake conversion. > > > > hi, i am trying to setup a verada front brake setup on my 1600, but > > instead of using vl calipers, i am using vt calipers. > > they will not bolt up to 180b or 1600 struts, as i was told. > > i used a verniers to measure the holes on the vt caliper, > > from the outer side of each hole it measures approx (3.475") 88mm. > > from the inner side of each hole it measures approx (2.52") 64mm. > > the holes are 12 mm big. > > therefore i need a strut with caliper mounting holes approx 76 mm apart. > > is there a strut suitable, or do i need a adapter etc,,,,,????? > > > > > > mark k > > > > > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[EMAIL PROTECTED]/ ---------------------------------------------------------------------
