These areas are easy to reach with a spot welder and not readily seen unless you climb into the boot, so I would spot weld a piece of replacement metal under the rusty section, if it's only in the channel itself, after cutting out the rusty pieces. Don't glue the rubber seal back in he channel. Glue a new seal around the boot lid, about 20mm further out from the channel. The right seal will keep most water out but still allow any that gets past it to drain in the channel without getting in the boot.
********************************************************************** Any personal or sensitive information contained in this email and attachments must be handled in accordance with the Victorian Information Privacy Act 2000, the Health Records Act 2001 or the Privacy Act 1988 (Commonwealth), as applicable. This email, including all attachments, is confidential. If you are not the intended recipient, you must not disclose, distribute, copy or use the information contained in this email or attachments. Any confidentiality or privilege is not waived or lost because this email has been sent to you in error. If you have received it in error, please let us know by reply email, delete it from your system and destroy any copies. ********************************************************************** --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[EMAIL PROTECTED]/ ---------------------------------------------------------------------
