Re: electronic ignition

[mark krawczuk]

hi,   as u look at the  4 pin module  , with the pins pointing up, and closest to you ,   the connections from left to right are :   minus signal         plus signal         ign 12 v+         coil neg.      for the two signal wires, you might have to try them either way round  (depends if the module was taken of ...)(also i think  one spade terminal is small and the  others are the larger type, if they are then u dont have to worry about getting them the right way....)   the 12 v +     and the   + of coil goes to  a switched  +12v source. the coil neg goes  er , um er  ummmmm to the negative of the coil !!!! make sure u use a coil that is suitable with      electronic ignition..... you do not need a  ballast resister....   the  neg ative of coil is  always switched,  this way the  pos supply is always   `in the coil and charged  ..`    . if u switched  the pos supply, it would take longer for the coil to  `charge...~     mark   k         --------------------------------------------------------------------- "Are you still wasting your time with spam?... There is a solution!"   Protected by GIANT Company's Spam Inspector The most powerful anti-spam software available. http://mail.spaminspector.com     ----- Original Message ----- From: daniel foster To: membersozdat@datascribe.com.au Sent: Tuesday, March 08, 2005 6:57 PM Subject: electronic ignition hi guys im thinking of putting a series 2 bluebird electronic dissy on my worked L18 and was wondering if it is a straight bolt on project or if i have to get something altererd on the dissy. And can any one tell me of a good plugs, leads and coil combination for my engine any help apreciated   Find local movie times and trailers on Yahoo! Movies. --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to membersozdat@datascribe.com.au No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to membersozdat@datascribe.com.au No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------