And, shark bite fittings tend to be expensive. I think I would use PEX
fittings and the crimp rings. You will need the crimp tool as well as
the cutter for removing rings when you mess up or decide to change
something.
I have not used them for air but I probably should install a line in my
garage too.
I have used PEX for changes to the water lines at my house and the
cottage with no issues so far.
Randy
On 24/11/2023 10:13 AM, MB list etc via Mercedes wrote:
Good luck with that - in my experience, shark bite fittings don't reliably hold
60psi water, much less 100+ psi of air though I've never tried it.
On Thursday, November 23rd, 2023 at 10:37 PM, Kaleb Striplin via Mercedes
<mercedes@okiebenz.com> wrote:
Instead of a kit I think I’m going to use pex and shark bit fittings along with
ball valves I already have. It appears this will be cheaper.
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
