Check your value to question #83 in Machine Define John
On Wednesday, March 01, 2000 2:01 PM, Wilson, Andrew [SMTP:[EMAIL PROTECTED]] wrote: > Good morning, > In advanced milling no matter what I set the Clearance value to, the code > outputs an 'R" value of .1 in > above the surface. > If I set a clearance of .2 in... it outputs R.100 > What am I missing??? Below is a copy of the canned cycle section in the .tmp > file. > > @FXD1 > < #RTNLVL>< #FXD>< X#XPOS>< Y#YPOS>< Z#ZDPTH R#ZCHK><F#FEED> > > Thanks > > > Andrew Wilson > CNC Programmer/Systems Admin > > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
