Re: [mfg-smartcam] Code generator question

[Dave Wolfgang]

Sorry at the end of your @ENDPROF   < #DCOMP>   Dave Wolfgang CNC Programmer/Supervisor www.hrindustries.net ----- Original Message ----- From: Gary To: Smartcam Users Group (E-mail) Sent: Monday, March 01, 2004 11:17 AM Subject: [mfg-smartcam] Code generator question I am trying to create a code generator from scratch for a wire edm machine. I have annoying issue witch I am sure there is simple solution. After I cut a profile I need to make a series of clearance moves. All is well but my out put looks like this. G00 G40 Xxxxx Yxxxx G00 G40 Xxxxx Yxxxx G00 G40 Xxxxx Yxxxx An I want it to look like G00 G40 Xxxxx Yxxxx G00 Xxxxx Yxxx G00 Xxxxx Yxxx G00 Xxxxx Yxxx Basically if the comp was canceled I do not need the G40 again until I turn it on again.   Any help is appreciated.   Gary