Andrew I had the same trouble
Here is haw I fixed it @DRILL1 #EVAL (#ZCHK=#ZCHK+.1) <#ABSI ><#RTNLVL ><#FXD ><X#XPOS ><Y#YPOS >< Z#ZDPTH R#ZCHK>< F#FEED > I still setup all tools to have a clearance of Z.1 and it is then anjusted in the *.tmp file. I only add to the tap in the *tmp to give the taping head enought room to clear the top of the part. I hope this helps Later Brock -----Original Message----- From: Wilson, Andrew <[EMAIL PROTECTED]> To: 'SmartCAM users group' <[EMAIL PROTECTED]> Date: Wednesday, March 01, 2000 8:25 AM Subject: [mfg-smartcam] code generator question >Good morning, > In advanced milling no matter what I set the Clearance value to, the code >outputs an 'R" value of .1 in >above the surface. >If I set a clearance of .2 in... it outputs R.100 >What am I missing??? Below is a copy of the canned cycle section in the .tmp >file. > >@FXD1 >< #RTNLVL>< #FXD>< X#XPOS>< Y#YPOS>< Z#ZDPTH R#ZCHK><F#FEED> > >Thanks > > > Andrew Wilson >CNC Programmer/Systems Admin > > >====================================================================== >To find out more about this mailing list including how to unsubscribe, >send the message "info mfg-smartcam" to [EMAIL PROTECTED] >====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
