Jon, would you post the @OP_BORE section (or whatever section your using to bore) of your template file? ============================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> http://www.highsteel.com <http://www.highsteel.com/> =============================================
-----Original Message----- From: Jon Baker [mailto:[EMAIL PROTECTED]] Sent: Thursday, December 07, 2000 6:45 PM To: [EMAIL PROTECTED] Subject: [mfg-smartcam] No G80 Hey, who added this twist to me. I am programming away, and need to add a point after a bore so the tool will move out of the way before tool changing. So I process out my code, and it does the bore, then DOESN'T call a G80 up before calling out the point location. This will cause my machine to bore again at the new location. Strangely, this is the first time I have run into this, as generaly after using a hole cycle, you cancel out and change tools immediately. Any suggestions as to where in my tmp file I need to do something? Thanks in advance Jon ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
