Shoot, I will post the whole enchilada if you want to look at it. Thanks ----- Original Message ----- From: "Lauzus, Frederick" <[EMAIL PROTECTED]> To: "Jon Baker" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]> Sent: Friday, December 08, 2000 8:18 AM Subject: RE: [mfg-smartcam] No G80
> Jon, > > would you post the @OP_BORE section (or whatever section your using to bore) > of your template file? > ============================================= > Fred Lauzus, CAM Programming Coordinator > High Steel Structures, Incorporated > mailto:[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> > http://www.highsteel.com <http://www.highsteel.com/> > ============================================= > > > -----Original Message----- > From: Jon Baker [mailto:[EMAIL PROTECTED]] > Sent: Thursday, December 07, 2000 6:45 PM > To: [EMAIL PROTECTED] > Subject: [mfg-smartcam] No G80 > > > Hey, who added this twist to me. > I am programming away, and need to add a point after a bore so the tool > will move out of the way before tool changing. So I process out my code, > and it does the bore, then DOESN'T call a G80 up before calling out the > point location. This will cause my machine to bore again at the new > location. Strangely, this is the first time I have run into this, as > generaly after using a hole cycle, you cancel out and change tools > immediately. > Any suggestions as to where in my tmp file I need to do something? > Thanks in advance > Jon > > >
4thaxis.tmp
Description: Binary data
