Re: [mfg-smartcam] No G80

[Michael DeBerry]

Try removing the #IF(#FXD=0). When the program coded was there a G80 at the rapid point after the boring cycle?   Mike DeBerry ----- Original Message ----- From: Jon Baker To: [EMAIL PROTECTED] Cc: [EMAIL PROTECTED] Sent: Friday, December 08, 2000 7:51 AM Subject: Re: [mfg-smartcam] No G80   Well Gene, that works, however, it also puts a G80 at every rapid positioning move in the program.  Any other suggestions?   Jon     Jon,   Try adding this:    #IF(#FXD=0)< #FXD>   To @RAP and @STPROF   See what happens.   Gene Bowen   Subject: [mfg-smartcam] No G80