Title: Untitled Stationery
|
I didn't know that. Thanks.
----- Original Message -----
Sent: Monday, March 04, 2002 12:20
PM
Subject: RE: [mfg-smartcam] CUTTER
COMP.
Dave,
You
are correct. However, even if you do have "Line Offset Match" checked, a
lead-in produced using "Reference Point" will have no
offset.
Chris
Chris,
I believe Lead In/Out will create the lines
without offset regardless of whether you use Ref. Point or not. Just be sure
Line Offset Match is not checked.
Dave
----- Original Message -----
Sent: Monday, March 04, 2002 10:25
AM
Subject: RE: [mfg-smartcam] CUTTER
COMP.
Colin,
I think what you need to do is add a non-cutter
comp lead-in. Add the lead-in from the plunge location to the start of the
profile. If you use "Reference Point" to add the lead-in, it will
automatically be produced with no cutter comp.
Christopher Kocourek
Tool & Die
Designer
Flextronics Tool & Design
I need to program a slot that is
1.67 long and .75 wide using a 1/2 dia. endmill. I would to plunge at
one end of the slot and in the center then go around the slot. When I
use the cutter comp., it looks like the tool is being offset and
starting off center.
Thank you
Colin
Williams
WABTEC
CORPORATION CONFIDENTIALITY NOTE
The content contained in this e-mail
transmission is legally privileged and confidential information intended
only for the use of the individual or entity named herein. If the reader
of this transmission is not the intended recipient, you are hereby
notified that any dissemination, distribution, or copying of this
transmission is strictly
prohibited.
|
