I need to program a slot that is 1.67 long
and .75 wide using a 1/2 dia. endmill. I would to plunge at one end of the slot
and in the center then go around the slot. When I use the cutter comp., it looks
like the tool is being offset and starting off center.
Thank you
Colin
Williams
WABTEC CORPORATION CONFIDENTIALITY NOTE
The content contained in this e-mail transmission is legally privileged and confidential information intended only for the use of the individual or entity named herein. If the reader of this transmission is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this transmission is strictly prohibited.
