We have a Dainichi lathe with a
Fanuc control 21-T.
I will be programming 4
different parts at one time each with a bar pull, in other words when one part
is complete it gets parted off, then we send in the stock stop and pull out the
required length for the next piece and so on. Because each part has a different
length I would like to program each piece at "Z 0". Our control does not have
the option for fixture offsets (G54-G59), which would have
been easier.
Is there a solution to get each
piece to have a "Z 0"
Thank you
Colin Williams
WABCO Freight Car Products
Phone: 905-561-8700 ext.227
Fax: 905-561-6616
Email: [EMAIL PROTECTED]
WABTEC CORPORATION CONFIDENTIALITY NOTE
The content contained in this e-mail transmission is legally privileged and confidential information intended only for the use of the individual or entity named herein. If the reader of this transmission is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this transmission is strictly prohibited.
