We use
the G26 code on our Bostomatic control to zero our new X0Y0Z0
location
after
moving from one vice to the other, as it dose not have any fixture offset
capabilities.
N23
Z2.0R
N24 XV30YV31R FROM VICE 1 TO VICE 2
N25 G91
N26 ZV34R
N27 G90
N28 G26X0.0Y0.0Z2.0
N24 XV30YV31R FROM VICE 1 TO VICE 2
N25 G91
N26 ZV34R
N27 G90
N28 G26X0.0Y0.0Z2.0
This
is how we get back to VICE1 from VICE2
N59
Z2.0R
N60 X-V30Y-V31R FROM VICE 2 TO VICE 1
N61 G91
N62 Z-V34R
N63 G90
N64 G26X0.0Y0.0Z2.0
N60 X-V30Y-V31R FROM VICE 2 TO VICE 1
N61 G91
N62 Z-V34R
N63 G90
N64 G26X0.0Y0.0Z2.0
The
variable V30 is for the x-axis, and it is the distance from one vice X0 to the
other vice X0.
The variable V31
is for the y-axis, and it is the distance from one vice Y0 to the other vice
Y0.
The variable V34 is for the z-axis, and it is the distance
from one vice Z0 to the other vice Z0.
-----Original Message-----
From: Andy Beardmore [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, October 29, 2002 9:56 AM
To: '[EMAIL PROTECTED]'; Smartcam Forum (E-mail)
Subject: RE: [mfg-smartcam] Lathe offsetsHave you got G10 (programmable offset) function on the control?-----Original Message-----
From: Williams, Colin [mailto:[EMAIL PROTECTED]]
Sent: 29 October 2002 13:55
To: Smartcam Forum (E-mail)
Subject: [mfg-smartcam] Lathe offsetsWe have a Dainichi lathe with a Fanuc control 21-T.I will be programming 4 different parts at one time each with a bar pull, in other words when one part is complete it gets parted off, then we send in the stock stop and pull out the required length for the next piece and so on. Because each part has a different length I would like to program each piece at "Z 0". Our control does not have the option for fixture offsets (G54-G59), which would have been easier.Is there a solution to get each piece to have a "Z 0"Thank youColin WilliamsWABCO Freight Car ProductsPhone: 905-561-8700 ext.227Fax: 905-561-6616Email: [EMAIL PROTECTED]
WABTEC CORPORATION CONFIDENTIALITY NOTE
The content contained in this e-mail transmission is legally privileged and confidential information intended only for the use of the individual or entity named herein. If the reader of this transmission is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this transmission is strictly prohibited.
