There are (2) G76 lines when cutting
threads, what is the required fields for the second G76 line. I am cutting 3/4 -
14 npt internal.
In particular the "R" which represents the
taper value. I'm getting different answers from different sources about
this.
Thank you.
Colin Williams
WABCO Freight Car Products
Phone: 905-561-8700 ext.227
Fax: 905-561-6616
Email: [EMAIL PROTECTED]
***** CONFIDENTIALITY NOTE *****
The content contained in this e-mail transmission is legally privileged and confidential information intended only for the use of the individual or entity named herein. If the reader of this transmission is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this transmission is strictly prohibited.
