Looks like most of you are suggesting the starter solenoid.  I'll order up a 
new one tomorrow and report back shortly.

Cheers!

Matt
  ----- Original Message ----- 
  From: Steve Ashcraft 
  To: Matthew Goertz ; [email protected] 
  Sent: Wednesday, April 16, 2008 5:01 PM
  Subject: Re: Intermittent power content



   
  I chased the same problem for about a year.  Seemed to be worse once the car 
was completely warmed up.  I decided that a 17 year old wiring harness wasn't 
worth replacing so I removed the cigarette lighter, put in a starter switch ala 
Honda S2000, and ran new wires from the starter button to the starter and now 
it works every time.   Of course, this is a race car and I don't worry too much 
about resale. 
  Good luck.
  Steve

  ----- Original Message ----
  From: Matthew Goertz <[EMAIL PROTECTED]>
  To: [email protected]
  Sent: Wednesday, April 16, 2008 1:30:14 PM
  Subject: Intermittent power content


  So today, I'm having a new issue with my car.  Car is a 90 Canadian base, 
with 107,000 kms.

  What it's doing:

  Starts first try, 90% of the time.  Once in a while though, I turn the key, 
and here's what happens:

  Dash lights come on (CEL etc, radio works, no problems).  Turn the key to 
start position, relay clicks, but car doesn't start.  Embarassing when trying 
to impress your date.  Turn the key 5-10 times on and off, finally the car 
starts.

  Here's some data:

  New battery from the dealer October 2007.  Fully charged and used daily.
  New starter installed by a mechanic October 2007.  Remanufactured unit bought 
from FLAPS.
  Replaced ground cable from block to firewall with used piece October 2007.
  Car had been a theft recovery and had been hotwired.  4 wires to the ignition 
switch trimmed and soldered with appropriate wiring harness by mechanic.  I 
watched him use proper shrink wrap, not just electircal tape.

  My question:

  What's the most likely culprit for the intermittent starting?  Where should I 
start looking?  I'm thinking the ground off the engine block is the most likely 
problem, since it was installed by me in the cold, and I might not have cleaned 
the contact points thoroughly enough.  What should I check after that (since 
it's the simplest place to start).  Solenoids?  Wiring to starter?  Wiring 
harness continuity?

  Ideas?  Recommendations?

  Cheers!

  Matt

  PS:  Please help me so I can continue to impress the ladies!




------------------------------------------------------------------------------


  No virus found in this incoming message.
  Checked by AVG. 
  Version: 7.5.524 / Virus Database: 269.23.0/1381 - Release Date: 4/16/2008 
9:34 AM
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to