That sounds rather unsafe.... ;-)
Ken On Thu, Jun 16, 2011 at 3:10 PM, Jesus Lara <[email protected]> wrote: > What I've done in the past is put 12v on the ~1/4 inch connector on the > starter solenoid. Just make a jumper wire from that to a handy 12v > source. The starter will engage and spin as soon as you do so make sure its > in neutral. > > > On 6/16/2011 1:19 PM, [email protected] wrote: > > I use a 21mm socket on a wratchet to turn the pulley bolt. > > The clutch safety switch is located above the clutch pedal. It is the white > box switch about 1.5" and .5" in size with two 10 ga wires coming out of > it. > > > > -----Original Message----- > From: derf <[email protected]> > To: Miata Power List <[email protected]> > Sent: Thu, Jun 16, 2011 2:14 pm > Subject: Under Hood Starter? > > Is there a clever way to bump the starter on a Miata from under the > hood? Where are the starter relay and clutch switch located? > > Having to get in the car, depress the clutch, and turn the key gets > old after a while when you just want to bump the crank 1/4 turn. > _______________________________________________ > Miatapower mailing list > [email protected] > http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower > > _______________________________________________ > Miatapower mailing list > [email protected] > http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower > > _______________________________________________ > Miatapower mailing list > [email protected] > http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower > > _______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
